close
Advertisement
Shop Now
Magazine
 

How to build a retaining wall – fast!

DIY expert Frank Gardner needed to find a simple system for installing a retaining wall in a just a day.

How to build a retaining wall – fast!
Reader's Digest

DIY expert Frank Gardner needed to find a simple system for installing a retaining wall in a just a day.

‘The wall had to go up before the house extensions blocked access to the yard so I had to move fast,’ says Frank.
 
‘I found the Retain-iT system at the hardware store and liked how the galvanised posts would look with pine sleepers. I added pine capping and a set of wide steps.’
 
How to build a retaining wall – fast!

To start, establish the line of the wall, excavating 200mm behind it, then use a laser level or dumpy to set the finished height of the wall either end, setting out a stringline as a guide. 
 
‘Be sure to install drainage behind the wall using geotech filter cloth, agflo pipe and gravel,’ says Frank.
 
TIP Check local council regulations as many allow a wall up to 600mm high to be built without approval.
 

Calculating the materials

‘I went three sleepers high and opted for a sleeper thickness of 75mm for strength and less timber flexibility.
 
‘The posts were concreted into the ground at a maximum of 2400mm apart on the sandy site,’ says Frank.
 
Measure the length of the wall, setting the posts to match the sleeper sizes. Multiply the spacings between posts by the number of vertical sleepers to find how many you need.
 
‘I worked out I need 15 sleepers 2400mm long plus six each of 1200 and 1800mm for about 16 metres of wall with steps set in one panel.’

How to build a retaining wall – fast!

How to install a retaining wall

Step 1. End posts and joiner posts
Step 1. End posts and joiner posts
Reader's Digest

Excavate two 550mm deep holes for the end posts, pour in concrete to 600mm from the top, use a spirit level to check for plumb in both directions then check the post is the right height. TIP A 20kg bag of cement mixed with gravel and sand fills three holes.

Next, set up a stringline to use as a guide then position a base sleeper in each end post. Position the joiner posts then dig 550mm deep holes and concrete them into position using a spirit level to plumb, aligning them with the stringline and leaving to dry.



40 Incredible Christmas Tree Decorating Ideas
How To Clean The House In Your Sleep

9 Ways To Clean The House In Your Sleep

Some chores can take care of themselves while you snooze.
8 Of The Most Inventive And Original Christmas Tree Ideas

8 of the Most Inventive and Original Christmas Tree Ideas

Looking for different ways to decorate your home this festive season? Why not consider a novelty Christmas tree?
Make Your Own Hanging Christmas Tree Ornaments

Make Your Own Hanging Christmas Tree Ornaments in 5 Easy Steps

Make personalised Christmas ornaments using simple decoupage techniques.
Easy Christmas Crackers With A Tasty Surprise

Easy Christmas Crackers With A Tasty Twist

Pack three rum balls in a tube of paper inside a square of cellophane. Then twist the ends to make a cracker-shaped party favour.

Advertisement